Page 1 of 1
One off Snapon ratchet
Posted: Mon Mar 05, 2018 3:52 pm
by Snap-on Boy 92
Just made this little 1/4 drive flex head handle. Snapon never made a 1/4 stubby flex so I decided the wait was over and I would. Think it would be classed TKF72 let me know what you all think
Re: One off Snapon ratchet
Posted: Mon Mar 05, 2018 3:54 pm
by Snap-on Boy 92
This is compared to the 3/8 version
Re: One off Snapon ratchet
Posted: Mon Mar 05, 2018 4:31 pm
by Snap-on Boy 92
By the way this handle started life out as a bolt! Just thought I’d post this because most wouldn’t believe haha
Re: One off Snapon ratchet
Posted: Mon Mar 05, 2018 5:04 pm
by agmechjake
I made one out of a tf72. I cut it right at the first groove on the handle, then polished till the cut marks were gone.
Re: One off Snapon ratchet
Posted: Mon Mar 05, 2018 5:43 pm
by Snap-on Boy 92
Nice one, I decided to make a complete handle though as I liked the thought of a pear drop handle on the end rather than cutting one down. Also I fancied loosing a few hours of my day and giving my brain a challenge, no engineering back ground but I teach myself as I go on my millers and lathes so it was a good lesson for myself
Re: One off Snapon ratchet
Posted: Mon Mar 05, 2018 8:28 pm
by Oldtuleguy
Very professional job!
Re: One off Snapon ratchet
Posted: Tue Mar 06, 2018 9:06 am
by Snap-on Boy 92
Thank you very much appreciated
Re: One off Snapon ratchet
Posted: Fri Mar 09, 2018 6:32 pm
by JeepFan
Nice work. Looking at the beginning, the bolt, the end result is very impressive.
Re: One off Snapon ratchet
Posted: Sun Mar 11, 2018 8:07 pm
by Snap-on Boy 92
Thank you very much for the comment, I’ll be making plenty more little things like this in time to come for sure so keep a look out