Page 1 of 2
Nice to be back
Posted: Sun Feb 19, 2023 8:24 am
by snapmom
Thanks Frank
Re: Nice to be back
Posted: Sun Feb 19, 2023 9:57 am
by rustynuts
Yes ditto!!
Re: Nice to be back
Posted: Sun Feb 19, 2023 10:20 am
by Frank Murch
Sorry about the gap. The outside (COVID and Business) problems overwhelmed me.
The old site had problems that were growing and needed to be fixed. I was having trouble with the backend software - Dreamweaver. I wanted to move to WordPress but the site is massive. It took a lot of effort. This site (not the forum, but the rest of the site) is now in WordPress. I have lost the search index ability in the Catalogs. The Catalogs seem to have some problems, The page order and a couple are missing pages. In one case the image prespective is off - but I think I can work these issues out
On the site in general - Some of the pages are a little odd. I have the original pages, but not the navigation between them, so I also have all the drafts and duplicate pages. It has been difficult to see what was a draft and what was used. As a result, there is some confusion in some areas.
This morning the pictures in this forum were moved over and are "populating" now. These date back to 2010 so there are a large number of pictures reloading.
I feel that I let everybody down, and I certainly did, but the problems from the last couple of years have been horrific. Not health as much as business and income issues. But the site is back
Re: Nice to be back
Posted: Sun Feb 19, 2023 11:36 am
by ridgerambler
Thanks Frank!! You were missed.
Re: Nice to be back
Posted: Sun Feb 19, 2023 2:29 pm
by Cyberider
Thank you, Frank!
Re: Nice to be back
Posted: Sun Feb 19, 2023 6:41 pm
by toolnut
So glad to hear you're back Frank! And hello to everyone else out there again.
Re: Nice to be back
Posted: Mon Feb 20, 2023 7:29 am
by Eric in PA
Congrats on getting everything up and running again. Love this resource, use it all the time.
Re: Nice to be back
Posted: Mon Feb 20, 2023 5:11 pm
by Bill the Engineer
Hurray! It's back!
Re: Nice to be back
Posted: Tue Feb 21, 2023 9:38 am
by aeromechanix
Thank you very much, Frank for supporting this site. Very helpful historical information for Snap-On tool junkies!
Re: Nice to be back
Posted: Wed Feb 22, 2023 12:44 pm
by rallenc
Can't thank you enough for your efforts and commitment to keeping this site available to us tool junkies. I'm really looking forward to the discussions and learning from the many "masters".
Thanks again!!