15 High-speed single & double ended “END MILLS”. Of the 15 only three have been used and one of those three has one end broken off. (see photo) Included in the 15 is one new key cutter and one #3 Taper Pin Spiral Reamer with a 15/64 shank .04 per foot taper. Other shanks are ½, 3/8 and ¼ inch.
This lot would be an excellent bargain at $100.00, but you can buy these for $75.00 plus shipping of $5.90 anywhere in the United States.
End Mills for Sale WITHDRAWN
Forum rules
The owner of this board assumes no responsibility for the actions of people wishing to buy or sell items, it is merely for provided as an informational service. Use caution as you would with CraigsList.
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
The owner of this board assumes no responsibility for the actions of people wishing to buy or sell items, it is merely for provided as an informational service. Use caution as you would with CraigsList.
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
-
Ferret
- Posts: 66
- Joined: Mon Dec 26, 2011 7:34 am
- Your Location: Minnesota
- Contact:
End Mills for Sale WITHDRAWN
- Attachments
-
- IMG_2533.JPG (98.88 KiB) Viewed 1026 times
-
- IMG_2531.JPG (88.56 KiB) Viewed 1026 times
-
- IMG_2530.JPG (97.77 KiB) Viewed 1026 times
Who is online
Users browsing this forum: No registered users and 130 guests