Have recently inherited a used Snap-On CG-500 stud remover/re-setter (15-piece SAE set). Unfortunately, the instruction sheet was missing from the box. I don't want to damage the tool so would like to learn the proper procedure for using it before putting it into service. I know there are recommended torque values for the various collets as well as various "dos and don'ts". Does anybody here have an instruction sheet for this tool that they could send me a scan of?
Thanks for your time.
Looking for instruction sheet
Forum rules
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
-
MoparXXXVII
- Posts: 3
- Joined: Sat May 19, 2012 3:56 pm
- Your Location: California
- Contact:
-
MoparXXXVII
- Posts: 3
- Joined: Sat May 19, 2012 3:56 pm
- Your Location: California
- Contact:
Re: Looking for instruction sheet
OK: found it.
In case anybody else wants it, here's a link:
http://www.hydrameconline.com/.search?q ... 0&use_boss
Click on "Blue Point" about halfway down the page. That will give you a PDF to download. When it opens, you have to blow it up to about 200% to make it legible.
In case anybody else wants it, here's a link:
http://www.hydrameconline.com/.search?q ... 0&use_boss
Click on "Blue Point" about halfway down the page. That will give you a PDF to download. When it opens, you have to blow it up to about 200% to make it legible.
Who is online
Users browsing this forum: Ahrefs [Bot] and 121 guests