No. 71 Pan Heads
Forum rules
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
-
L32Elwell
- Posts: 3
- Joined: Thu May 31, 2012 4:39 pm
- Your Location: Carnegie, Pa
- Contact:
No. 71 Pan Heads
I recently picked up a No.71 which has the pan head screws holding in the interference fit cover. Unfortunately one of the screws has been replaced. Both screws look aged so I have no idea as to which one is correct. They are both flat blade pan heads but one has a lower profile than the other. My guess is that the higher dome head is the incorrect one. I'm guessing somebody here may be able to tell me which is correct. Ill see if I can get a good picture uploaded. Thanks for your time and help.
- Attachments
-
- Copy of No 71 (2).JPG (18.72 KiB) Viewed 2774 times
-
- Copy of No 71.JPG (16.72 KiB) Viewed 2774 times
Last edited by L32Elwell on Sat Jun 02, 2012 5:16 pm, edited 1 time in total.
-
snapmom
- Posts: 1127
- Joined: Sun Oct 17, 2010 2:38 pm
- Contact:
Re: No. 71 Pan Heads
I can get a closer one if you need.
-
L32Elwell
- Posts: 3
- Joined: Thu May 31, 2012 4:39 pm
- Your Location: Carnegie, Pa
- Contact:
Re: No. 71 Pan Heads
Thanks... I think that settles it. It looks to be the lower pan head. That was quick
Who is online
Users browsing this forum: No registered users and 113 guests